This handle is designed for the winch of a 5" diameter flagpole equipped with an M-Winch.
**Special Website Pricing**
The “M” – Winch is gearless and self locking at any point, eliminating the need for a separate break. This direct drive winch provides for rapid raising & lowering of the flag with little effort. This improved design does not require any welding thus avoiding discoloration when an anodized finish is required. No monthly lubrication is needed and this winch system is easily adaptable to existing on-site flagpoles. The winch is inserted into the pole and secured with a stainless tell Bolton the back side of the pole. Winch handle sold separately.
This truck is cast aluminum, constructed for use on rope style internal halyard flagpoles. A small pulley assembly is affixed to the inside of the trick housing to allow the halyard to feed from inside the flagpole. The pulley assembly has a 2” outside diameter case nylon pulley on a 1/4" stainless steel axle. This truck is designed to be used on flagpoles that have up to a 3 1/2" outside top diameter with female fitting installed. The bottom of the spindle has a 1 1/4” NPT threading and is screwed into the top of the flagpole. The top of the truck will accept an ornament with 1/2"-13NC threading. The ornament is secured to the truck with a 1/4"-20NC stainless steel set screw. The maximum halyard diameter for this pulley is 5/16”.
This truck is cast aluminum with a 1 1/4” NPT threaded spindle which screws into the top of the flagpole where a female fitting has been installed. The top of all trucks are designed to accept an ornament with a spindle threading of 1/2"-13NC. The ornament is secured to the truck with a 1/4"-20NC stainless steel set screw. The extra large model has stainless steel ball bearings in both upper & lower bearing races. All sizes are supplied with a stainless steel bushing at the cable exit point except the 3” diameter model which has a bronze fitting.
This truck is cast aluminum, constructed for use on rope style internal halyard flagpoles. A small pulley assembly is added to the inside of a standard outrigger style truck to allow the halyard to feed from inside the flagpole. The internal pulley assembly has a 1 1/2” outside diameter cast nylon pulley and the external pulley assembly has a 1 1/2” outside diameter cast nylon pulley for the 3 1/2" truck and 2" outside diameter cast nylon pully for the 3" truck. All are on a 1/4" stainless steel axle and is designed to slip over the top of the flagpole and be secured with three 5/16”-18NC stainless steel set screws. The top of the truck will accept an ornament with 1/2”-13NC threading. The ornament is held in place by a size 10-32 stainless steel pan head screw. The maximum halyard diameter for this pulley is 5/16”.
...
FLAG CENTER - WAUWATOSA 2954 NORTH 117TH STREET WAUWATOSA, WISCONSIN 53222 PHONE 414-778-1776 HOURS: 9am-5pm M-F, 9am-Noon SAT
FLAG CENTER - OAK CREEK 7158 SOUTH 13TH STREET OAK CREEK, WISCONSIN 53154 PHONE 414-856-0040 HOURS: 9am-5pm M-F Closed SAT